Locks typically feature five tumblers, although some have six or even more. Whenever the drill bit comes into contact with each pin, you will experience resistance. You may now drill a hole in the lock’s cylinder to destroy the pins contained within the cylinder. Parting ShotĪs simple as that, you will have removed your ignition lock from its place.įAQs Is It Possible To Drill Out A Lock Cylinder? Gently slide the switch out of its place. Insert the screwdriver into the cylinder and turn it on the right as far as you can.Īfter that, pull the paperclip on the far right as much as possible. This will lock the cylinder and prevent the ignition from starting. Insert a straightened paperclip into the slot and turn to the left. So, in this case, you will need a power-drill with extractors to remove the bolts that mount the ignition switch to the steering column. The main role of this component is to prevent thieves from replacing your can ignition lock and driving it off without a key. Some car models have safety snap-off bolt heads. Step 7: Inspect The Mounting Bolts On The Ignition Switch Housing Alternatively, you can turn an ignition key in the accessories position. These cylinders can easily be removed by inserting a pin into a pinhole using the release mechanism. Most of the car models have an interchangeable lock cylinder. Unbolt the switch assembly and housing that contains the lock cylinder. Get a socket wrench or screwdriver to unscrew the mounting screws or bolts on the ignition switch. To pull the switch out, you will need to loosen the tabs and pull them out. Unscrew them and pull the ignition switch out.Ĭarefully disconnect wires from the connector on the rear side of the ignition switch. Locate the mounting screws on the ignition switch.
Step 5: Disconnect All Electrical Connection Leading To Ignition Switch Locate and slide it up after you have removed the indicator and wiper switches.
In the steering wheel column, you will find spacer columns. Step 4: Remove Sleeves From Steering Column Locate these two switches and pull them away from their place. Step 3: Remove Indicator and Wipers Switches Retain the washers and nuts as you remove the steering wheel.įinally, pull the steering wheel from its shaft. Remove the screws to remove the lower and upper cover from the steering wheel column.Īfter you have removed the covers, lift the wheel up – pull at the center cover. The next thing you will need to do is to remove the steering wheel from its place so that you can access the ignition lock cylinder. With the negative terminal removed, you will be safe to work on your car. Remove negative cable terminal to disconnect the battery. This will ensure that you don’t get electrocuted or short anything in the car. The first thing you need to do is to disconnect your battery. All of these tools are available on Amazon. To successfully remove the ignition lock cylinder without a key, you will need to have the following critical tools.
0 kommentar(er)
